华电技术 ›› 2018, Vol. 40 ›› Issue (7): 50-53.

• 技术交流 • 上一篇    下一篇

新型350MW超临界供热机组调试期间故障分析及处理

  

  1. 1.西安热工研究院有限公司,西安〓710032; 2.深能保定发电有限公司,河北保定〓072150
  • 出版日期:2018-07-25

Fault analysis and treatment during commissioning period of a new 350MW supercritical heating unit

  1. 1.Xi’an Thermal Power Research Institute, Xi’an 710032,China; 2.Shenzhen Energy Baoding Power Generation Company Limited, Baoding 072150, China
  • Published:2018-07-25

摘要:

哈尔滨汽轮机厂有限责任公司350MW高、中压分缸供热机组采用了新型汽封,提高了缸效率,但也给汽轮机的启动和运行带来一定的问题。针对该机组调试期间出现的机组轴承振动大、低压轴封带水、高压缸轴封端漏汽量大等故障,通过现场排查,采取了增加暖机转速点、优化阀门流量控制、加固振动测量支架、消除汽缸膨胀受阻、转子高速动平衡校正等处理措施后,消除了机组存在的主要故障,保障了改型机组顺利通过168h满负荷试运行。

关键词:

Abstract:

The 350MW heating unit with separated high and medium pressure subcylinder which is made by Harbin Steam Turbine Factory Company Limited takes a new steam sealing to improve cylinder efficiency. But it also brings certain problems to the start and operation of the steam turbine. During commissioning period of the unit, there were large bearing vibration, water contained in lowpressure shaft seal, serious steam leakage of highpressure cylinder at shaft end and other faults. Through the onsite troubleshooting, measures such as increasing the rotation rate set point of units warming , optimizing the valve flow control, reinforcing the vibration measuring bracket, eliminating the cylinder expansion resistance, and correcting the highspeed dynamic balance of rotor were taken. After the treatment, the main faults in the generating units are eliminated, which ensures the 168hour successful trial of the retrofit unit with full load.

Key words: