凝汽器真空度下降原因分析及处理

华电技术 ›› 2014, Vol. 36 ›› Issue (9): 49-50.

凝汽器真空度下降原因分析及处理

(广东粤电集团靖海发电有限公司，广东靖海〓515223)

出版日期:2014-09-25

Analysis on reasons of decreasing of condenser vacuum degree and treatment

(Guangdong Yudean Jinghai Power Generation Company Limited, Jinghai 515223, China)

Published:2014-09-25

摘要/Abstract

摘要： 摘要：针对广东粤电集团惠来电厂 #1机组凝汽器真空度下降的现象，通过检查及分析，确认真空泵工作液温度、给水泵机械密封水回水调整门开度、主机轴承箱底部排油管穿凝汽器孔洞泄漏等因素对真空度的影响，采取相应处理措施后，凝汽器真空度恢复正常，提高了机组运行的安全性及经济性。

关键词: 关键词：凝汽器, 真空度, 真空泵工作液, 给水泵密封水回水, 轴承箱排油管

Abstract: Abstract:The condenser vacuum degree of the unit No.1 in Huilai Power Plant of Guangdong Yudean Group decreased. The system was investigated and analyzed, and it was determined that the factors influencing on the condenser vacuum degree are the temperature of the vacuum pump working liquid, the opening of the adjust valve of backwater of feed pump mechanical sealing water, the leakage of the hole on the condenser wall, through which the oil discharge pipe of the bearing box passes, and so on. The relevant treatment measures were adopted, and the condenser vacuum degree returned to normal value. The safety and the economic efficiency of the unit operation were improved.

Key words: Keywords:condenser, vacuum degree, vacuum pump working liquid, backwater of feed pump sealing water, oil discharge pipe of bearing box

曹叶. 凝汽器真空度下降原因分析及处理[J]. 华电技术, 2014, 36(9): 49-50.

CAO Ye. Analysis on reasons of decreasing of condenser vacuum degree and treatment[J]. Huadian Technology, 2014, 36(9): 49-50.

[1]	王敏1，王杰2. 600MW超临界机组凝汽器真空度低的原因分析及治理[J]. 华电技术, 2019, 41(3): 59-61.
[2]	谌丽1，吴春潮2. 1050MW机组石膏含水率高的原因分析及处理[J]. 华电技术, 2018, 40(5): 56-57.
[3]	万志勇. 真空泵切换过程中真空度突降的原因分析及应对措施[J]. 华电技术, 2016, 38(5): 52-53.
[4]	韩丽娜，李绍刚，王刚. 凝汽器抽真空系统的节能改造[J]. 华电技术, 2016, 38(5): 70-73.
[5]	谢冰. 非典型凝汽器海水泄漏原因分析及对策[J]. 华电技术, 2015, 37(6): 64-65.
[6]	王刚. 凝汽器真空度降低原因分析及诊断方法[J]. 华电技术, 2015, 37(3): 34-37.
[7]	潘广强，郑效宏. 330MW机组凝汽器换型改造及节能效果分析[J]. 华电技术, 2014, 36(7): 44-46.
[8]	赵志祥 1，王文兵 2 . “离心闪蒸脱水”新技术阻断真空滤油机跑油事故分析[J]. 华电技术, 2014, 36(5): 21-22.
[9]	曲海英，孙磊. 1000MW机组凝结水溶解氧超标的原因分析及治理措施[J]. 华电技术, 2014, 36(2): 69-72.
[10]	黄文耀 1，肖铁红 2. 导致汽轮机组运行故障的因素分析[J]. 华电技术, 2013, 35(8): 43-45.
[11]	付冬苗1，黄校春2. 凝汽器铜管冲击腐蚀穿孔的分析与镀膜防护处理[J]. 华电技术, 2013, 35(6): 58-60.
[12]	韩琴;许晓斌;常浩. 火电机组耗差分析中真空度基准值的计算分析[J]. 华电技术, 2013, 35(3): 16-19.
[13]	王惠新. 330 MW汽轮机低压缸排汽系统优化改造[J]. 华电技术, 2013, 35(2): 1-3.
[14]	董霖;曾雅洁;马勇. 660 MW海勒式间接空冷机组试运中出现的问题及处理措施[J]. 华电技术, 2013, 35(1): 38-41.
[15]	李铁军. 循环水余热利用系统存在的问题及改造[J]. 华电技术, 2012, 34(8): 68-72.