35t/h启动锅炉超温分析与技术改造

华电技术 ›› 2018, Vol. 40 ›› Issue (12): 13-15.

35t/h启动锅炉超温分析与技术改造

1.华能云南滇东能源有限责任公司滇东电厂，云南曲靖〓655508； 2.西安热工研究院有限公司，西安〓710054

出版日期:2018-12-25 发布日期:2019-01-28

Overtemperature analysis and technical transformation of 35t/h auxiliary boiler

1.Diandong Power Plant,Huaneng Yunan Diandong Energy Company Limited, Qujing 6555082, China; 2.Xi’an Thermal Power Research Institute Company Limited, Xi’an 710054, China

Online:2018-12-25 Published:2019-01-28

摘要/Abstract

摘要：

为解决某机组启动锅炉点火后出现蒸汽超温引发频繁跳机的问题，结合现场运行数据确认低负荷下燃烧器出力过大、各级受热面吸热量不匹配为蒸汽超温的主要原因，在此基础上提出了包含燃烧器、减温水、炉膛烟道改造及炉内燃烧调整的综合方案。通过增设燃烧器回油旁路增大回油量，降低了油枪出力；利用二次风旋流挡板调整火焰形状，增加水冷壁吸热量；通过实施炉膛烟道改造，重新分配烟气流量，减少过热器吸热量；更换大孔径减温水喷嘴，提高对蒸汽温度的控制能力。改造调整后，启动锅炉运行稳定，超温停机现象基本消除，蒸汽参数达到设计值，相关经验可供后续同类设备参考。

关键词:

">">启动锅炉, 超温, 吸热量匹配, 技术改造, 燃烧调整

Abstract:

In order to solve the frequent tripping caused by steam over temperature after the start up of a unit and ignition of the boiler, combined with the field operation data, it is confirmed that excessive output of the burner under low load and the mismatching of heat absorption on different levels heating surface are the main reasons for the overheating of the steam.Accordingly, a comprehensive plan including burner, desuperheating water, furnace flue modification and furnace combustion adjustment is proposed.By adding a burner back leakage bypass, back leakage can be increased and nozzle output can be reduced. By using the secondary air swirl baffle and adjusting the flame shape, heat absorption capacity of the water wall can be improved.By implementing the furnace flue transformation and redistribution flue gas flow,the heat absorption of the superheater can be reduced.By replacing a largeaperture desuperheating water nozzle, the control of the steam temperature can be improved. After retrofit, startup of boiler is stable, and overtemperature shutdown is basically eliminated, and steam parameters of the boilers are basically reach the design value. Relevant experience can be used for reference by similar equipment in the future.

Key words:

auxiliary boiler, overtemperature, heat absorption matching, technical transformation, combustion adjustment

李茂1，游必超1，后颖黎1，王林2. 35t/h启动锅炉超温分析与技术改造[J]. 华电技术, 2018, 40(12): 13-15.

LI Mao1，YOU Bichao1，HOU Yingli1，WANG Lin2.

Overtemperature analysis and technical transformation of 35t/h auxiliary boiler

[J]. Huadian Technology, 2018, 40(12): 13-15.

[1]	闫新春, 曹欢, 华云鹏. 基于人工智能的锅炉受热面管壁温度预测[J]. 综合智慧能源, 2022, 44(3): 58-62.
[2]	蔡雨晴1，杨平1，沈丛奇2，康英伟1，归一数2，徐春梅1. 单相受热管集总参数模型优化及现代控制工程应用[J]. 华电技术, 2019, 41(6): 1-5.
[3]	万立明1，梅振锋2，李德波3，苏朋1，邱家煜1. 中速磨煤机入口紧凑型圆形一次风道流场均流技术研究[J]. 华电技术, 2019, 41(6): 6-12.
[4]	胡美玲1，赵雪瑞2，赵耀丽2. 基于以太网的水电站卷扬式启闭机控制系统的设计[J]. 华电技术, 2019, 41(6): 13-16.
[5]	梁鹏威，康振全，黄浩然，马莉莉，刘洪星，朱朝磊. 基于ANSYS的齿轮模态特性研究[J]. 华电技术, 2019, 41(6): 17-22.
[6]	张巍1a，周国鹏1b，汪洋1a，倪浩1a，钟著辉2. 一起220kV主变压器保护装置发TV异常告警的原因分析[J]. 华电技术, 2019, 41(6): 23-26.
[7]	牛腾赟. 某电厂发电设备可靠性建模及状态预测[J]. 华电技术, 2019, 41(6): 27-32.
[8]	谢坤1,2，赵谦1,2，程成1,2，李帅1,2，蔡亮亮1,2. 具有异常分析功能的通用型数字量输入式合并单元[J]. 华电技术, 2019, 41(6): 33-37.
[9]	苏攀，沈阳，于鹏峰，韩静. 正平衡供电煤耗升高原因分析及煤耗修正计算[J]. 华电技术, 2019, 41(6): 38-41.
[10]	王晓华，谈志林，宫建，李连军. 燃煤电厂氟塑料换热系统的技术经济分析[J]. 华电技术, 2019, 41(6): 42-45.
[11]	徐克涛，何永兵，裴煜坤，张杨. 某燃煤电厂SCR脱硝装置堵塞问题分析及改进[J]. 华电技术, 2019, 41(6): 46-49.
[12]	叶罗，吴俊东，陈显. 低温省煤器系统运行实践分析[J]. 华电技术, 2019, 41(6): 50-52.
[13]	靳军，种西虎，李广伟. 空气预热器排烟温度偏差分析[J]. 华电技术, 2019, 41(6): 53-56.
[14]	马亮. 基于主汽压动态特性的机组协调预测控制研究[J]. 华电技术, 2019, 41(6): 57-60.
[15]	杨亚龙，李春庆，王永，赵颖. 沉管过河施工中供热管道的安全性验算分析[J]. 华电技术, 2019, 41(6): 61-63.