国产300MW汽轮机侧齿汽封应用分析

华电技术 ›› 2013, Vol. 35 ›› Issue (5): 7-9.

国产300MW汽轮机侧齿汽封应用分析

张泉

(广东省粤电集团有限公司韶关发电厂，广东韶关512000)

收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2013-05-25 发布日期:2013-05-25

Analysis on application of lateral tooth steam seal in domestic 300MW steam turbine

ZHANG Quan

(Guangdong Yudean Shaoguan Power Plant, Shaoguan 512000, China)

Received:1900-01-01 Revised:1900-01-01 Online:2013-05-25 Published:2013-05-25

摘要/Abstract

摘要： 以某发电厂国产300MW机组汽轮机端部汽封的改造为例，分析了传统汽封存在的不足，介绍了侧齿汽封的特点。将该厂汽轮机端部汽封改为侧齿汽封后，汽轮机端部轴封漏汽量减少0.45～0.85t/h，大大降低了润滑油中的微水含量，提高了汽轮机高中压缸效率，降低了机组汽耗。

关键词: 汽轮机, 轴封, 侧齿汽封, 漏汽

Abstract: Taking the reformation of terminal steam seal of the domestic 300MW unit turbine in a power plant as example, the deficiencies of the traditional steam seal were analyzed. The features of the lateral tooth steam seal were introduced. After the terminal steam seal of the steam turbine in the power plant was transformed into lateral tooth steam seal, the steam leakage of the terminal shaft seal of the turbine decreased by 0.45～0.85t/h，the microwater content in lubrication oil decreased significantly, the efficiency of HP and IP cylinder was improved, and the steam consumption of the unit was reduced.

Key words: steam turbine, shaft seal, lateral tooth steam seal, steam leakage

张泉. 国产300MW汽轮机侧齿汽封应用分析[J]. 华电技术, 2013, 35(5): 7-9.

ZHANG Quan. Analysis on application of lateral tooth steam seal in domestic 300MW steam turbine[J]. Huadian Technology, 2013, 35(5): 7-9.

[1]	陈啸，徐威，刘利，陈鑫. 某600MW机组汽轮机异常振动的分析及处理[J]. 华电技术, 2019, 41(7): 64-66.
[2]	贤建伟，代术建. 300MW亚临界汽轮机快速结垢原因分析及处理[J]. 华电技术, 2019, 41(5): 78-.80.
[3]	张大佳，杨鹏. 6F.01燃气轮机液压油系统调试故障分析及处理[J]. 华电技术, 2019, 41(3): 29-31.
[4]	王敏1，王杰2. 600MW超临界机组凝汽器真空度低的原因分析及治理[J]. 华电技术, 2019, 41(3): 59-61.
[5]	宋馨. 汽轮机轴封蒸汽温度波动原因分析与解决方案[J]. 华电技术, 2019, 41(2): 46-48.
[6]	王治辉，宋志强，王钢锋，于泳. 铜川照金电厂汽轮机汽流激振的原因分析及处理[J]. 华电技术, 2019, 41(2): 46-48.
[7]	马仁婷. 全容量给水泵汽轮机保护系统可靠性分析及优化措施[J]. 华电技术, 2019, 41(10): 60-63.
[8]	罗云，薛荣波，晁俊凯，任海彬，贺学军. 660MW间接空冷机组小汽轮机改造[J]. 华电技术, 2019, 41(10): 76-80.
[9]	刘冠军. 东汽X300P型汽轮机轴向间隙计算及胀差大原因分析[J]. 华电技术, 2019, 41(1): 40-44.
[10]	于淑慧. 高背压供热改造中给水泵汽轮机控制方式研究[J]. 华电技术, 2019, 41(1): 64-66.
[11]	冯光明. 除氧器进汽逆止阀失效暗藏机组跳闸风险[J]. 华电技术, 2019, 41(1): 72-73.
[12]	刘强. 汽轮机安全监视系统设备存在的问题及防范措施[J]. 华电技术, 2018, 40(9): 30-31.
[13]	虞涌. 600MW汽轮机全实缸汽封间隙调整工艺[J]. 华电技术, 2018, 40(9): 44-46.
[14]	安宗武1，孟颖琪1，刘超1，李长海1，吴忠胜2. 新型350MW超临界供热机组调试期间故障分析及处理[J]. 华电技术, 2018, 40(7): 50-53.
[15]	孙海元. 某电厂330MW汽轮机冷态启动用时过长原因分析及处理[J]. 华电技术, 2018, 40(7): 54-55.