华电技术 ›› 2010, Vol. 32 ›› Issue (12): 61-63.

• 技术交流 • 上一篇    下一篇

锅炉启动过程受热面安全分析与防止超温的控制措施

徐军涛,刘志杰   

  1. 河南中孚实业股份有限公司电力二分公司,河南巩义451200
  • 收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2010-12-25

Analysis on safety of heating surface in boiler starting up process and control measures for overtemperature prevention

XU Juntao, LIU Zhijie   

  1. Second Electric Power Branch of Henan Zhongfu Industry Corporation Limited, Gongyi 451200, China
  • Received:1900-01-01 Revised:1900-01-01 Published:2010-12-25

摘要: 河南中孚实业股份有限公司电力二分公司300MW锅炉在启动阶段时常发生汽包上/下壁温差大、低温过热器超温严重、空气预热器电流波动大的问题,使整体启动时间较难控制,对金属材料的寿命构成了严重的威胁,且点火时间延长,势必造成燃油量增大、发电量减少的双重损失。对锅炉启动过程受热面安全问题进行了分析,提出了在多次启动运行实践过程中总结出来的防止超温的措施。

关键词: 水冷壁, 汽包, 温差, 超温, 锅炉启动, 受热面

Abstract: Some problems occurred in starting process of the 300MW boiler of Second Electric Power Branch of Henan Zhongfu Industry Corporation Limited, which include larger temperature difference between the drum’s upper wall and lower wall, serious overtemperature of the low temperature overheater, greater fluctuation of the air preheater current. Due to these problems, the control of whole starting time became more difficult, the life of the metal materials were imperiled seriously; and the long ignition time will cause increase of the fuel oil consumption and decrease of generated electricity.In this paper the safety of the heating surface in boiler starting process was analyzed, and the measures for overtemperature prevention were put forward, which were summarized according to many times starting practices. 

Key words: water wall, steam drum, temperature difference, overtemperature, boiler start-up, heating surface