Huadian Technology ›› 2018, Vol. 40 ›› Issue (10): 65-68.

Previous Articles     Next Articles

Application of centrifugal dust removal and demisting technology with condensation wet film in WFGD system

  

  1. 1.Demister(Shanghai) Environmental Technology Company Limited,Shanghai 200120, China; 2.Huadian Inner Mongolia Energy Company Limited,Baotou 014000, China
  • Online:2018-11-26 Published:2018-12-13

Abstract:

In order to fulfill the requirement of thermal power units’ ultralow emission, the mass concentration of dust in flue gas should be lower than 5mg/m3 and the mass concentration of slurry should be lower than 20mg/m3, which request a 70%  removal rate on average among various exhausted flue gas particles whose diameters are smaller than 3.5μm. However, the ordinary demist device and the wet electrostatic precipitator afterwards in the desulfurization system can barely remove the nanoscale particles in the flue gas. According to the principle of condensed phase transition which can cool the wet flue gas after desulfurization, a centrifugal dust removal and demisting technology with condensation wet film is recommended.The precipitated water vapor can ‘capture’the micronsized particles which can form large droplets after recondensing and be removed by the demister. This technology can effectively remove particulate matter (dust, slurry) smaller than 3.5μm in flue gas, and at the same time take into account the liquid level balance of desulfurization tower, save water consumption in the system, and significantly improve units’ economic efficiency.

Key words: