I/A’Series控制器双重启故障原因分析及处理

华电技术 ›› 2012, Vol. 34 ›› Issue (5): 60-62.

I/A’Series控制器双重启故障原因分析及处理

毛奕升

广东珠海金湾发电有限公司，广东珠海519050

收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2012-05-25

Reason analysis and treatment of restarting fault of I/A Series two controllers

MAO Yisheng

Guangdong Zhuhai Jinwan Power Generation Company Limited, Zhuhai 519050, China

Received:1900-01-01 Revised:1900-01-01 Published:2012-05-25

摘要/Abstract

摘要：

广东珠海金湾发电有限公司 #3， #4机组脱硫控制系统采用了福克斯波罗公司的I/A’Series分散控制系统，系统内的控制器会随机出现单个或者1对控制器离线重启的

现象，严重威胁了机组安全、稳定运行。对系统管理计数器、控制器同步记录进行分析，确认了网络问题；对节点总线网络进行监控并分析各站间的数据流，最终确认厂级信息监

控系统数据采集和发送程序Opifox造成了脱硫分散控制系统节点总线网络堵塞，从而导致控制器同步不一致而重启。通过更换数据采集和发送程序，最终解决了这一难题。

关键词: 分散控制系统, 控制器重启, 厂级信息监控系统, Opifox, 节点总线

Abstract:

In the desulphurization control system of units No.3 and No.4 in Guangdong Zhuhai Jinwan Power Generation Company Limited, the Foxboro I/A Series

distributed control system is adopted. The off-line and restarting phenomenon of single or double controllers in system occurred randomly, which threatens

the safe and stable operation of the unit severely. The synchronous records of the system management counter and the controller were analyzed to determine

the network problem; the node bus network had been monitored, and the data streams between stations were analyzed. It was determined finally that the data

acquisition and send program of the supervisory information system in plant level, Opifox, caused the congestion of the node bus network of desulphurization

distributed control system, which makes the two controllers to be asynchronous and to start up again. The data acquisition and send program had been

replaced, and at last, the difficult problem was solved.

Key words: distributed control system (DCS), controller restarting, supervisory information system (SIS) in plant level, Opifox, node bus

毛奕升. I/A’Series控制器双重启故障原因分析及处理[J]. 华电技术, 2012, 34(5): 60-62.

MAO Yisheng. Reason analysis and treatment of restarting fault of I/A Series two controllers[J]. Huadian Technology, 2012, 34(5): 60-62.

[1]	马亮，付冉. 火电厂脱硫分散控制系统信号干扰故障分析[J]. 华电技术, 2019, 41(9): 53-55.
[2]	张松奇，杨勇，许涛. 基于DCS的布袋除尘器脉冲阀顺序控制改造分析[J]. 华电技术, 2019, 41(2): 76-77.
[3]	肖胜1，郭伯春2. 新旧分散控制系统更换改造探讨[J]. 华电技术, 2017, 39(9): 31-33.
[4]	吴胜华，田海波. DCS中4~20mA电流冗余输出实现方法分析[J]. 华电技术, 2017, 39(4): 44-45.
[5]	常绪成1，孔冰2. 纯凝机组供热改造中热工自动化系统的方案设计[J]. 华电技术, 2016, 38(4): 35-36.
[6]	赵娜1，张振伟2. DCS改造中锅炉侧顺序控制逻辑优化[J]. 华电技术, 2016, 38(2): 44-47.
[7]	高瑞斌，许尧. 超临界机组DCS改造对机组经济运行的影响[J]. 华电技术, 2016, 38(11): 45-47.
[8]	吴科，马振华，朱能飞，陈玉年. 国产maxDNA大型分散控制系统在1000MW机组一体化控制中的应用 [J]. 华电技术, 2015, 37(8): 6-9.
[9]	王丹麟，吴胜华，马伟东. maxDNA分散控制系统I/O模件冗余实现机制[J]. 华电技术, 2015, 37(4): 22-24.
[10]	吴胜华，田海波，王丹麟. DCS过程控制站内IO模件地址重叠识别方法[J]. 华电技术, 2015, 37(3): 29-30.
[11]	陈乐. 分散控制系统流量补偿计算组态的应用[J]. 华电技术, 2014, 36(9): 16-18.
[12]	李秋枫，刘淑伟. 600MW机组分散控制系统功能完善[J]. 华电技术, 2014, 36(8): 14-16.
[13]	姚秀娟，赵连莉，刘三，朱延忠. 600MW机组脱硫烟气换热器吹灰控制系统改造[J]. 华电技术, 2014, 36(6): 69-72.
[14]	王芳栋，王洁. 空气预热器扇形板间隙控制系统改造[J]. 华电技术, 2014, 36(2): 53-54.
[15]	吴军. 基于maxLINKS的一体化监控方案在超超临界机组的应用[J]. 华电技术, 2014, 36(10): 19-22.